Lw-measurements LBS Large Bench Scale User Manual download pdf (Page 13)

− Press the HOLD key again to enter the next menu, the

display will show CAP. Press the UNIT key to select

full capacity. Press the UNIT key to move the flashing

digit to the right, press the ZERO key to increase the

flashing digit, and press the HOLD key to confirm the

selection.

− Press the HOLD key again to enter the next menu, the

display will show CALU=. Press the UNIT key to

select calibration unit kg or lb (lb cannot be selected if

lb was disabled in the Function setting – Working

mode Sec 4.2.3). Press the HOLD key to confirm the

selection.

− Press the HOLD key again to enter the next menu, the

display will show CAL. Press the UNIT key to set the

calibration weight. Press the UNIT key to move the

flashing digit to the right, press the ZERO key to

increase the flashing digit. Press the HOLD key to

confirm the selection. NOTE: The calibration weight

should be more than 2/3 of the full capacity.

− Press the HOLD key again to enter the next menu, the

display will show DIV. Press the UNIT key to select

division. Press the HOLD key to confirm the

selection.

− Press the HOLD key again to enter the next menu, the

display will show Adb. Press the UNIT key to select

(19.20). Press the HOLD key to confirm the selection.

− Now start the calibration following the next steps:

− Press the PRINT key, the display will show CAL and

then the AD value. Press the UNIT key when the

stable indicator light is displayed, it will show the

flashing calibration weight.

− Place the known test weight on the platform, press the

UNIT key after the stable indicator light is displayed, it

will show ------, and then the AD value.

− Turn off the weighing machine, remove the test weight

from the platform.

− Press ON/OFF key to turn the machine on to test if

the weighing is accurate, if not, repeat above steps.

1 2 ... 8 9 10 11 12 13 14

No comments

Lw-measurements LBS Large Bench Scale User Manual Page 13